During the installation process, please follow the steps below to prevent damage to the camera:
Connect the camera to the terminal to ensure that the camera device captures a normal image.
Place the camera in the desired installation position and adjust the tilt angle of the camera to confirm that the captured image is normal.
Record the installation position and camera calibration.
Maintain the camera at the adjusted angle and use a hex screwdriver to tighten the inner hex screw hole that adjusts the viewing angle.
Remove the protective film from the double-sided adhesive on the camera, and install the camera at the recorded position. Secure it with self-tapping screws.
If there is any deviation in the camera's vertical angle after installation, repeat steps 2, 3, and 4 to fine-tune the tilt angle of the camera.
